Locksmith Almoradí Town · pedanías · huerta Call 24h

After the water

A cylinder full of Segura silt

River water carries fine mud into every lock it covers, and as that mud dries it sets. What to do with your locks in the first days after the water goes down, why oil makes it worse, and how to tell when a cylinder is finished.

Almoradí lies in the middle of the Segura’s floodplain. When the river broke its wall in September 2019, the water came into the town through the Las Maromas estate, and two days later through a second break in the levee by El Gabato. In parts of the municipality it stood more than a metre deep. The huerta had been covered before, in 1987. Each time, once the water went down, the same problem appeared in the locks a few days later.

Why a lock that worked on Monday is stuck on Friday

Flood water is not clean water. It carries fine silt, and it gets into everything below the waterline: the keyway of the cylinder, the gaps between its pins, the lock body inside the door, the bolt and the hole it shoots into. While the silt is wet it stays soft, and the key still turns. As it dries, it packs round the pins and the springs and sets hard. Steel parts start to rust within days.

So a lock that seemed fine straight after the flood can seize a week later, often when the house is finally being locked up properly again.

In the first days

  • Photograph each door and lock before you clean anything. The insurer will want to see the damage as it was. The note on what the insurer asks for after flood water goes through the rest.
  • Work the key while the silt is still soft. If the key turns, turn it fully a few times in each direction, and work the handle, so the parts are not left set in one position.
  • Flush with clean water only. A gentle rinse into the keyway from a bottle can carry some silt out. Let it drain and dry.
  • Leave doors that matter unlocked if it is safe to, rather than locking a cylinder you are not sure will open again.

Three habits that make silt worse

  • No oil, no grease, no general-purpose spray. It mixes with the silt into a paste that holds the pins even more firmly, and it collects new dust afterwards.
  • No forcing a key that will not turn. A key snapped in a silted cylinder turns a cleaning job into a drilling one.
  • No heat. A hair dryer or a heater will dry the silt faster, which is the opposite of what you want, and can damage plastic parts in multipoint locks and electronic keypads.

Saved or finished?

A cylinder that comes apart cleanly, with no rust on its pins or springs, can be cleaned, dried, put back with a dry lubricant and used for years. One with rusted springs, or silt packed into the lock body behind it, is cheaper to replace than to rescue. Shutter locks and padlocks on gates, which spent longest underwater, are usually replaced.

Electronic locks and safes are a separate case: see an electronic safe in a house that took water. Once everything works again, it is a good moment to look at a planned lock change across the house.

Would a voice on the phone be quicker?

Ring, or send a photo of the door or the lock on WhatsApp, and you will hear what it needs.

Open 24 hours · 7 days

Call 24h WhatsApp (opens WhatsApp)